Epoxy kit High Build 40cc.

RV excellent processing High Build epoxy for finishing wrappings. This epoxy is suitable for processing quite thick. Comes in two syringes of 20cc. Features a fine processing epoxy with enough processing time. Remains flexible and does not crack or tear. Exellent levelling and most bubbles disapear by themselves. Use a blue flame or a hairdryer to get rid of last bubbles. Better not continue prosessing when the epoxy gets too thick, mix a new amount.

This set contains

- two syringes A and B part - a total of 40cc epoxy finish
- four brushes - five mixing cups - three mixing sticks 

Processing

- blend well rotating slow with spatula 1:1 ratio processing temp. preferably above 18 °C 
- processing time approx. 25 min - after applying rotate for 3 to 5 hours depending on ambient temperature 
- for rotating use a rod dryer - or use mirror ball motors 3 to 5 rotations per minute
- mix at least a total of 4cc. A + B part in a cup - after the processing check for air bubbles after about 10 min.
- remove the last bubbles using blue flame or hairdryer - dust dry after 4/5 hours
- preferably apply second layer within 24 hours - full hardening after 48 hours (at 18 °C) 
- process in a ventilated sufficiently heated room
- clean tools with thinner - 40cc is generally enough epoxy for 3 up to 6 rods